Set the idle back to 1,000rpm after you tweak each carb, and open the throttle fully and let it snap shut a couple of times after you sync them all, then check and adjust again as necessary. 13,750 mile 1972 Honda CB350K4 This motorcycle maintains its original parts and has undergone a recent FRESHENING including: POR-15 Frame Coat, VHT High Heat Engine Paint, Ultra-Sonic Carb Cleaning and carb adjustment, all aluminum, chrome and bolts de-rusted, polished and waxed, all original paint work buffed, polished and waxed, seat cleaned and conditioned, timing set, new spark plugs. Take your time, and follow the instructions.
![motionpro carb sync honda cb360 motionpro carb sync honda cb360](https://images1.americanlisted.com/nlarge/1976-honda-cb360-cafe-racer-americanlisted_30011231.jpg)
Put a rag in the valley of the engine, over the coolant hoses/fittings and so that it lays between your hand and the engine. You can stick your hand in the valley, hold the socket in your fingers and turn the screws from there.ģ. Use a 7mm, 1/4" drive socket to adjust the throttle screws. Free shipping on many items Browse your favorite brands affordable prices.
#MOTIONPRO CARB SYNC HONDA CB360 PRO#
Remove the left side cover (the plastic-chrome one under the tank), the frame that holds it, and disconnect the clutch cable at the big (14mm head) bolt and let it hang out of your way. Get the best deals on Motion Pro Other Motorcycle Parts for 1971 Honda SL175 when you shop the largest online selection at. I got them all as close as was possible with my gauges, I'm guessing I achieved the 20mmHg spec in the manual. Vapor blasting can remove dirt, contaminants, rust, corrosion, and old paint while gently cleaning the surface. Vapor blasting is a non-aggressive surfacing process that provides a high-quality finish even on delicate surfaces. I'm hoping my gas mileage improves, but I'm not holding my breath, because the carbs were all within 4" (100mm) mercury of each other to start. We offer Vapor Blasting (also known as wet blasting or vapor honing) on all Non-Ferrous Metals and plastic. The results were nice, better throttle response, smoother low-rpm riding and better idle. I just finished synchronizing my carbs and taking a test ride.